welcome to . . .

 

 h p c w o r l d

 

PRODUCT INFORMATION
TOOLS
SAFE & SAFE DEPOSIT
LOCK TOOLS

Door Puller & Nose Puller
for Safe Deposit Boxes
DP-7B

If the lock core has been pulled and use of the guard key has not opened the door, then it is time to apply the Door Puller Set.

Place the stepped Spacer Block onto the hook unit. The 3 different diametered steps of .345" (2.15cm), .562" (1.43cm) and .680" (1.73cm) make it adaptable to 3 different sizes of plug holes. Place the correct diameter step into the hole. Have the hook end set against the inside back wall of the door, then tighten the knurled nut to hold the hook in place. The flat surface on the outside of the hook unit should be in a level position.

The long flat blade is then fitted onto the holding slot, along with the remainder of the Puller unit, as shown above. Position feet away from the centers of adjacent doors, to minimize the possibility of distortion. The knurled knob is then turned until the door is pulled out.


No. DP-7B
Door & Nose Puller for Safe Deposit Boxes
includes
Nose Puller Set No. NP-4B - All within a Steel Carrying Case
(Above image shows the complete Door Puller Set in position
and ready to pull out the safe deposit door.)

Replacement Parts for the Door & Nose Puller Set:
No. DP-7B-1
No. DP-7B-2
No. DP-7B-3
No. DP-7B-4
No. DP-7B-5
No. DP-7B-6
No. NP-4B-4,5		 Hooked Anchoring Post
Knurled Nut only, to fit Anchor Post & Leg
3 Diameter Spacer Block
Flat Blade
Slotted Leg with Foot
Handle
Ball Thrust Bearing & Knurled Knob for Thrust Bearing

For instructions on this product please click here.


tools / hpc home page

© 2005 HPC, Inc.